Now Accepted

Face Driver Request Form

The following information is needed to determine the correct type and size of face driver for your application. Click here to download request form in pdf format.

Full Name	*
Organization	*
Phone
FAX
E-mail	* Required

Operation Type
- Type of Operation	Lathe Grinder Mill Gear Hobb
- Make of Machine:
- Model:
Face Driver Mounting
Mount on Spindle Face	- Spindle Nose Size:
Morse Taper Mount	- Morse Taper Size:
Sub Plate Mount on Power Chuck Face, Rotary Table or Fixture
Hold with Power Chuck
Condition of Operation
- Direction of Rotation
Bi-Directional Clockwise (M4 Code) Counterclockwise (M3 Code)
- Rotation Speed:
- Feed Rate:
- Depth of Cut (Max):
Workpiece (Fill data below or attach part drawing)
- Type:
- Material:
- Weight:
- Max. Diameter (D1):
- Driving Diameter (D2):
- Chamfer (C1):
- T.I.R. Desired:
- Hardness:	BHN
	Rc
- Datum of Length:	Center Face
- Length (L1):
- Center Size (D3):
- Attach Drawing:
Tailstock

- Type:	Without Bearing (Use Live Center for Turning) Built-In Bearing (Dead Center)
- Maximum Thrust:
- Morse Taper Size:
Thrust is not line pressure, it is line pressure multiplied by cylinder size=thrust. Please check machine manual or contact LMC regarding use of a thrust gage.
Power Source
- Type of Operation:	(for Face Driver Type FFB with Actuator)
Air	Maximum Pressure
Hydraulic	Maximum Pressure

I would like to receive your future e-mails for online specials.

Yes No

Where did you find us?

Special Request:

Enter Security Code:

Back to Top

LMC Workholding
P.O. Box 7006 • 1200 West Linden Avenue
Logansport, IN 46947-7006 USA
Phone: 574-735-0225 • Fax: 574-722-6559
E-Mail: info@LMCworkholding.com