|
|
|||
|
|
|||
 |
|||
 |
 |
 |
|
Now Accepted |
|||
LMC Workholding
Company and Product News
LMC FDNC Gear-Hobb
Face Drivers Improve Turning Productivity
Gear hobbing is now easier and more productive with FDNC gear-hobb face drivers from LMC Workholding, part of the company’s line of workholding products.
With FDNC Face Drivers, hobbing can now be done in one operation eliminating the use of a chuck. These new face drivers also deliver high-tolerance concentricity / run out specifications of .00003 to .00007. Also, the center pin and drive disk system can be adjusted to achieve zero run out.
Using a FDNC Face Driver allows the entire workpiece to be exposed for machining and turned in one operation, which eliminates a step in the production process and reduces cycle time. Also efficiency and accuracy are improved since hobbs stay on one machine and tolerance stack-ups are eliminated. What’s more, the single-axis reference point established by the face driver’s center point allows for a higher concentricity.
LMC gear-hobb face drivers are available in flange mount and two shank styles: Morse-taper and straight shank. Specials are available that are produced to customer specifications and needs.
FDNC Face Drivers also offer a quick-change drive disk for faster job changeovers, optional coolant flush and spring-loaded or fixed-center pin. Drive disks are available in clockwise, counterclockwise and bi-directional drive disks.
LMC makes a complete line of face drivers that use quick-change center points and drive pins for increased productivity and cost efficiency.
Contact LMC Workholding, P.O. Box 7006, Logansport, IN 46947-7006, telephone 574-735-0225, fax 574-722-6559.
LMC Workholding
P.O. Box 7006 • 1200 West Linden Avenue
Logansport, IN 46947-7006 USA
Phone: 574-735-0225 • Fax: 574-722-6559
E-Mail: info@LMCworkholding.com